Isuzu Trooper>> Body>> Salon>> Glass and window regulator

9.8.3. Glass and window regulator

GENERAL INFORMATION

Windshield and regulator of a window regulator of the Trooper/Bighorn car

1 – trench of a guide of a window regulator
2 – glass
3 – window regulator regulator handle
3a – the window regulator regulator with the electric drive
4 – external sealant
5 – внутреннмй sealant
6 – motionless glass assembled
7 – cover of mobile section

Back glass and regulator of a window regulator of the Trooper/Bighorn car

1 – trench of a guide
window regulator
2 – sealant
3 – window leaf
4 – internal sealant
5 – external sealant
6 – glass
7 – window regulator regulator
7a – the window regulator regulator with the electric drive
8 – window regulator regulator handle
8a – the window regulator switch

Regulator of back and forward window regulators of the Rodeo/Passport car

1 – window regulator switch
2 – button frame
3 – trash bin
4 – slip
5 – decorative panel
6 – arm
7 – water filter
8 – glass
9 – window leaf
10 – the window regulator regulator with the electric drive
11 – internal handle
12 – the door lock with the electric drive
13 – trench of a guide of a window regulator
14 – external handle

Prevention

Electric motors of window regulators of the Isuzu cars are built in the uniform block of the regulator of side glass.


Procedures of removal and replacement are similar to the same procedures for the manual drive of glasses. Manipulations with the internal door handle are applicable for window regulator switches.

Removal and installation

PERFORMANCE ORDER
1. Before works it is necessary to disconnect wires from the regulator.
Amigo/MU/Jazz cars
2. Remove the panel of a door and the water filter.
3. Hook and get linear a sealant of glasses.
4. Unscrew screws of fastening of the lower trench to the regulator of a door and having inclined, get glass.
5. Unscrew screws of fastening of the regulator and get the regulator through an aperture in a door framework.
6. Installation is carried out upside-down.
7. Establish glass and be convinced of correctness of provision of the lower trench.
8. Establish linear a sealant of glasses so that the cut was turned inside.
Trooper/Bighorn and Rodeo/Passport cars
9. Remove the panel of a door and the water filter.
10. Hook and get linear a sealant of glasses.
11. Unscrew screws of a rotary window leaf and remove a window leaf, having pulled up.
12. Unscrew screws of the lower trench and remove door glass.
13. Unscrew screws of fastening of the regulator and get the regulator through an aperture in a door framework.
14. Installation is carried out upside-down.