Isuzu Trooper>> Body>> Back cover (cover of a cargo compartment or hatch)

9.3. Back cover (cover of a cargo compartment or hatch)

GENERAL INFORMATION

Back cover of the Amigo/MU/Jazz car

1 – latch
2 – hatch cover
3 – laying of a cover of the hatch
4 – laying of back lamps
5 – cover of wires
6 – bolt, nut and spring washer of the limiter
7 – limiter arm bolt
8 – arm
9 – loop bolt
10 – back cover

Top back cover of the Amigo/MU/Jazz car

1 – clamp
2 – handle
3 – cover rack bolt
4 – rack flange
5 – rack
6 – sharovy finger of a rack
7 – deflector bolt
8 – deflector sealant
9 – nut of the deflector and top cover
10 – flange of the deflector and top cover
11 – top back cover
12 – a loop nut from a body
13 – loop of the top cover
14 – deflector
15 – sealant
and – to a body

Lower back cover of the Amigo/MU/Jazz car

1 – bolt of a cable of the drive of the lower cover
2 – cable of the drive of the lower cover
3 – flange of the lower cover
4 – loop bolt
5 – lower back cover
6 – loop
7 – the torsion knot
8 – decorative slip
9 – details of internal facing
10 – details of internal facing
11 – details of internal facing
12 – protection against water penetration
13 – waterproof cover
14 – draft of control of the lock
15 – draft of control of the lock
16 – holder of draft
17 – draft of the cylinder of the lock
18 – lock of the lower cover
19 – bolt of fastening of an aktyuator of the lock
20 – handle
21 – sealant
22 – lock drive cylinder
23 – aktyuator

Back cover of the Trooper/Bighorn car

1 – top loop

2 – lower loop

Removal

PERFORMANCE ORDER

Prevention

Works should be performed together.


1. Remove the internal panel of a back cover to provide access to wires. Disconnect wires and take aside.
2. Turn off a bolt and a nut of levers of the limiter (if are provided).
3. Remove a washer of levers of the limiter (if are provided).
4. Disconnect a rack of a back cover (if it is provided).
5. Turn off bolts of fastening of loops of a cover (the assistant has to hold a cover at this time) and uncover.

Installation

PERFORMANCE ORDER
1. Grease loops, bolts of loops, carving openings and the limiter with jellied lubricant.
2. Expose a cover and wrap bolts of loops.
3. Tighten bolts, but do not tighten.
4. Slowly cover a cover and adjust its situation. Not to slam a cover.
5. Open a cover, release bolts and adjust so that gaps on perimeter were identical, and the cover appeared aflush with a body.
6. After adjustment tighten bolts with m 22–30 N.' moment.
7. Adjust a lock clamp for what release bolts and displace a clamp easy blows of the plastic hammer. The clamp has to settle down parallel to a lock rotor. With a clamp it can be necessary for exact adjustment of gearing of the lock to establish one-two laying.
8. Tighten clamp bolts with m 12 N.' moment.