Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
   8.1. Adjustment of drum brakes
   8.2. Pedal
   8.3. Braking signal switch
   8.4. Main cylinder of brakes
   8.5. Vacuum amplifier of brakes
   8.6. The dosing valves
   8.7. Hoses of brakes
   8.8. Removal of air from a hydraulic actuator of brakes
   8.9. Disk brakes
      8.9.1. Blocks of disk brakes
   8.10. Brake support
   8.11. Brake disk
   8.12. Drum brakes
   8.13. Anti-blocking system of brakes of back wheels
   8.14. Specifications of brakes
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Brake system>> Disk brakes

8.9. Disk brakes

8.9.1. Blocks of disk brakes

GENERAL INFORMATION

Details of a forward disk brake

1 – hose
2 – bolt
3 – slips with plates
4 – bracket
5 – support assembled
6 – support arm
7 – disk and nave

Details of a back disk brake

1 – hose, 2 laying, union bolt
2 – lever of the emergency brake
3 – bolt
4 – a bolt with a washer
5 – support assembled
6 – slips and brackets
7 – support arm

On the most part of cars the indicator of wear of blocks is provided. If when using of brakes squeal sounds, then check wear of blocks. If the plate of the indicator adjoins to a brake disk, then blocks should be replaced (having protected from harmful effects of the dust formed from wear of frictional material).

Removal

Unscrewing of the lower bolt

Tilting of a support

Removal of blocks and plates


PERFORMANCE ORDER
1. Remove a half of volume of liquid from the main cylinder.
2. Lift the car and establish on supports.
3. Remove a wheel.
4. Remove a brake support, without disconnecting a hydraulic actuator tube. Bind a support a wire piece, without allowing sagging on a hose.

Prevention

The design of knot of a wheel brake on a part of cars allows replacement of worn-out blocks without removal of a support. To provide access to blocks turn off the lower bolt and cast away a support.


5. Remove blocks and plates. Check a condition of a disk of a brake, if necessary to a proshlifuyta or replace. Before grinding measure thickness of a disk and compare with standard (value of thickness is cast on a disk).

Installation

PERFORMANCE ORDER
1. Drown the piston in the support cylinder by means of special adaptation. On back brakes of cars to drown the piston in the cylinder, it is necessary to turn the piston clockwise against the stop and to combine a rough part of the piston with the center of a support.
2. Slightly grease a back part of blocks and establish plates. Establish blocks on a support.
3. Establish a support, a wheel and lower the car.
4. Press a pedal several times that blocks nestled on a disk. Check liquid level, if necessary add.