Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
   7.1. Forward suspension bracket
   7.2. Angles of installation of wheels
   7.3. Back suspension bracket
   7.4. Steering
      7.4.1. A steering wheel without safety cushion
      7.4.2. A steering wheel with a safety cushion
      7.4.3. The switch of the index of turn (the combined switch)
      7.4.4. Key of the switch of ignition and lock of blocking of a wheel
      7.4.5. Lock of blocking of a wheel
      7.4.6. Steering column
      7.4.7. Steering drafts
      7.4.8. Steering mechanism
      7.4.9. The steering mechanism with the hydraulic booster
      7.4.10. Pump of the hydraulic booster
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries

Isuzu Trooper>> Suspension bracket and steering>> Steering>> Steering wheel with a safety cushion

7.4.2. A steering wheel with a safety cushion



Before dismantling of the wheel equipped with a safety cushion disconnect the battery from weight and reliably isolate a wire of a negative pole. Otherwise spontaneous operation of a pillow and traumatizing is not excluded.

Before performance of work wash up hands toilet soap and carefully wash away water, put on goggles and gloves. The module with a safety cushion should be held in hand a polyurethane cover from itself, the module should be stacked on a smooth surface a cover up.


1. Disconnect the battery from weight.
2. Unscrew module screws (it is specified by an arrow) with a safety cushion and disconnect wires.
3. Turn off a nut of a steering wheel and remove a washer.
4. Remove a steering wheel a special stripper.


1. Establish a steering wheel, dress a washer and wrap a nut.
2. Tighten a nut with m 25 N.' moment.
3. Attach wires and install the safety cushion module.
4. Connect the battery to weight.