Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
   7.1. Forward suspension bracket
   7.2. Angles of installation of wheels
   7.3. Back suspension bracket
   7.4. Steering
      7.4.1. A steering wheel without safety cushion
      7.4.2. A steering wheel with a safety cushion
      7.4.3. The switch of the index of turn (the combined switch)
      7.4.4. Key of the switch of ignition and lock of blocking of a wheel
      7.4.5. Lock of blocking of a wheel
      7.4.6. Steering column
      7.4.7. Steering drafts
      7.4.8. Steering mechanism
      7.4.9. The steering mechanism with the hydraulic booster
      7.4.10. Pump of the hydraulic booster
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Suspension bracket and steering>> Steering>> Pump of the hydraulic booster

7.4.10. Pump of the hydraulic booster

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Disconnect and muffle hydraulic actuator tubes on the pump of the hydraulic booster.
3. Take off a drive belt from the pump.
4. Turn off bolts of fastening of the pump to an arm, remove the pump.
5. Installation is carried out upside-down.
6. Connect the battery to weight and remove air from a hydraulic actuator (see below).

Adjustment of a belt

PERFORMANCE ORDER
1. Weaken adjusting bolts of the pump.
2. Press a finger on a belt between a roller of a natyazhitel and a pulley of the pump. The deflection of a belt has to be 10 mm.
3. Adjust a belt tension, turning the pump, tighten bolts.

Removal of air from a hydraulic actuator

PERFORMANCE ORDER
1. On the cold engine fill in liquid in a nutritious tank to normal level.
2. Warm up the engine up to the normal working temperature.
3. Stop the engine, check liquid level in a tank, add to normal level.
4. Start the engine and 3–4 times turn a wheel in both directions against the stop. It is forbidden to hold a wheel in extreme situation more than 5 sec., otherwise liquid will overheat.
5. Expose wheels in the provision of driving on a straight line, stop the engine. If it is necessary to add liquid, then make it not less than in 5 minutes.
6. If at liquid there are bubbles, then repeat the procedure.