Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
   7.1. Forward suspension bracket
   7.2. Angles of installation of wheels
   7.3. Back suspension bracket
   7.4. Steering
      7.4.1. A steering wheel without safety cushion
      7.4.2. A steering wheel with a safety cushion
      7.4.3. The switch of the index of turn (the combined switch)
      7.4.4. Key of the switch of ignition and lock of blocking of a wheel
      7.4.5. Lock of blocking of a wheel
      7.4.6. Steering column
      7.4.7. Steering drafts
      7.4.8. Steering mechanism
      7.4.9. The steering mechanism with the hydraulic booster
      7.4.10. Pump of the hydraulic booster
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Suspension bracket and steering>> Steering

7.4. Steering

7.4.1. A steering wheel without safety cushion

GENERAL INFORMATION

Details of a steering wheel and steering column

1 – a wheel with 3 spokes
2 – cover
3 – a wheel with 2 spokes
4 – lower casing of a steering column
5 – lock case
6 – steering column
7 – steering shaft
8 – top casing of a steering column

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. On a steering wheel with 2 spokes unscrew screws of a cover of a sound signal and disconnect contact of a signal.
3. On a steering wheel with three spokes remove a molding in the center of a wheel, having hooked it the small screw-driver.
4. On the cars equipped with the panel button of inclusion of a sound signal remove the button, having hooked it and having disconnected latches.
5. Turn off a nut of a steering wheel and remove a washer. Apply on a steering shaft and a wheel of a tag of mutual orientation (are specified by shooters) that at assembly not to violate the initial provision of a wheel.
6. Remove a steering wheel a special stripper.
7. At installation combine the tags put when dismantling, and establish a steering wheel, put on a washer and wrap a nut.
8. Tighten a nut with m 35 N.' moment.