Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
   7.1. Forward suspension bracket
      7.1.1. Torsion
      7.1.2. Shock-absorbers of a forward suspension bracket
      7.1.3. Top spherical support
      7.1.4. Lower spherical support
      7.1.5. Stabilizer
      7.1.6. Bars of racks
      7.1.7. Top levers of a suspension bracket
      7.1.8. Lower levers of a suspension bracket
      7.1.9. Pin
      7.1.10. Naves of forward wheels
   7.2. Angles of installation of wheels
   7.3. Back suspension bracket
   7.4. Steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries


http://lemon62.ru/smolensk/cat_1400.html



Isuzu Trooper>> Suspension bracket and steering>> Forward suspension bracket>> Naves of forward wheels

7.1.10. Naves of forward wheels

CARS WITH the FORMULA 4х4

Removal

PERFORMANCE ORDER
1. Lift the car and establish on supports. Remove forward wheels.
2. Remove a support of a brake and bind a wire, remove a board of a brake and a disk.
3. Get a half shaft from a nave.
4. Rasshplintuyte also turn off a nut, a vypressuyta a tip of steering draft from a pin eye.
5. Prop up the lower lever and disconnect the lower sharovy hinge from a pin.
6. Disconnect the top sharovy hinge from a pin.
7. Remove a pin.
8. A brass mandrel (1) beat out a holder (2) external bearings.

Installation

PERFORMANCE ORDER
1. Press a holder of the external bearing by means of a mandrel and a press. In the absence of a mandrel grind off on a sandpaper a holder of the fulfilled bearing on 0,25–0,50 mm and use as a mandrel. Do not damage a new holder as the bearing can quickly fail.
2. Tighten nuts of spherical hinges with m 90 N.' moment.
3. Establish a pin.
4. Tighten also to a zashplintuyta a nut of the top spherical hinge (the forelock replace).
5. Establish a tip of steering draft from a pin eye, tighten also to a zashplintuyta a nut.
6. Insert a half shaft into a nave.
7. Establish a dustproof cover, a brake disk (see subsection 8.11) and a support (see subsection 8.10).
8. Establish forward wheels and lower the car.