Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
   6.1. Manual transmission
   6.2. Automatic transmission
   6.3. Running gear
      6.3.1. Forward driveshaft, half shafts and CV JOINTS
      6.3.2. Internal CV JOINT
      6.3.3. Removal and installation of the forward driveshaft
      6.3.4. Dismantling of cardan hinges
      6.3.5. Back driveshaft
      6.3.6. Average support
      6.3.7. Zadny Bridge
      6.3.8. Forward leading bridge
         6.3.8.1. Details of the forward leading bridge
         6.3.8.2. Reducer epiploon
         6.3.8.3. A nave with manual blocking of the drive of a forward driving wheel
         6.3.8.4. Self-locking nave
         6.3.8.5. Reducer of the forward bridge
         6.3.8.6. Removal and installation of the forward bridge
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Transmission and running gear>> Running gear>> Forward leading bridge>> Nave with manual blocking of the drive of a forward driving wheel

6.3.8.3. A nave with manual blocking of the drive of a forward driving wheel

GENERAL INFORMATION

Nave details with manual blocking of a wheel (cars with a wheel formula 4х4)

1 – bolt
2 – cap and details
3 – lock ring and package of washers
4 – case and details
5 – kontryashchy washer
6 – nut
7 – nave and disk
8 – external bearing
9 – epiploon
10 – internal bearing
11 – gear coupling
12 – lock ring

13 – head of the gear coupling
14 – spring
15 – lead
16 – the holding ring
17 – spring and ball of a clamp
18 – ring
19 – lock ring
20 – coupling details
21 – lock ring
22 – ring
23 – laying

Dismantling

PERFORMANCE ORDER
1. Transfer a control lever the transfer case to situation 2H. Lift the car and establish on supports.
2. Rearrange a nave in the provision of free rotation.
3. Turn off bolts and take off a nave cap assembled.
4. Pressing a lead towards a coupling head, turn the coupling clockwise and remove the coupling assembled.
5. Get a lock ring and remove a coupling head. Take the measures excluding loss of a ball of a clamp.
6. Get a spring and a ball from a coupling head.
7. Press a ring from a head.

Prevention

It is forbidden to remove this ring the sharp tool.


8. Get a spring, a lock ring and a lead.
9. Get the holding ring from the coupling, having turned it counterclockwise.
10. Get all details from the case.
11. Remove a lock ring and get an internal ring and laying.

Assembly

PERFORMANCE ORDER
1. Grease a coupling head ring, an internal surface of a cap and an external surface of a head.
2. Install a lock ring and all removed details in the case.
3. Install the holding ring in the coupling, having turned it clockwise.
4. Install a spring, a lock ring and a lead in the coupling.
5. Napressuyte on a head a ring.
6. Establish a spring and a ball of a clamp in a head.
7. Establish a coupling head.
8. Establish a cap of a nave and wrap bolts.
9. Establish wheels and lower the car.