Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
   6.1. Manual transmission
   6.2. Automatic transmission
   6.3. Running gear
      6.3.1. Forward driveshaft, half shafts and CV JOINTS
      6.3.2. Internal CV JOINT
      6.3.3. Removal and installation of the forward driveshaft
      6.3.4. Dismantling of cardan hinges
      6.3.5. Back driveshaft
      6.3.6. Average support
      6.3.7. Zadny Bridge
         6.3.7.1. Details of the back bridge
         6.3.7.2. Removal and installation of the back bridge
      6.3.8. Forward leading bridge
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Transmission and running gear>> Running gear>> Zadny Bridge>> Removal and installation of the back bridge

6.3.7.2. Removal and installation of the back bridge

Removal

PERFORMANCE ORDER
1. Lift the car and establish on supports.
2. Disconnect shock-absorbers.
3. Disconnect tubes of a hydraulic actuator of brakes.
4. Disconnect a cable of the emergency brake.
5. Establish under the back bridge of a prop and turn off nuts of step-ladders of fastening of springs to a bridge beam.
6. Remove the back bridge.

Installation

PERFORMANCE ORDER
1. Installation is carried out upside-down.
2. Tighten nuts of step-ladders with m 47–60 N.' moment, bolts of shock-absorbers – with m 30–41 N.'s moment.
3. Remove air from a hydraulic actuator of brakes, check oil level in a case of the back bridge.