Isuzu Trooper>> Transmission and running gear>> Running gear

6.3. Running gear

6.3.1. Forward driveshaft, half shafts and CV JOINTS

GENERAL INFORMATION

AMIGO/MU/JAZZ, RODEO/PASSPORT AND TROOPER/BIGHORN CARS

Forward leading bridge and CV JOINTS

1 – a forward disk of a brake assembled with a nave, a rotary pin, a brake board, a rack and the lower arm of a rack
2 – driveshaft
3 – bolt
4 – washers
5 – forward bridge
6 – washers

Removal

PERFORMANCE ORDER
1. Lift the car and establish on supports.
2. Disconnect the forward driveshaft from differential.
3. Remove forward wheels and a towing frame.
4. Completely unload the torsion, having turned off bolts of adjustment of clearance.
5. Remove bars of racks of a forward suspension bracket.
6. Disconnect drafts of the stabilizer from the lower levers.
7. Remove supports of disk brakes, tie them a wire to a frame, not to disconnect the highway of a hydraulic actuator of brakes.
8. Disconnect hinges of steering racks.
9. Disconnect the top levers of a suspension bracket from a frame, pay attention to quantity of adjusting washers of levers and their arrangement.
10. Disconnect steering drafts from the lower levers.
11. Disconnect shock-absorbers from the lower levers.
12. Remove the lower levers of a suspension bracket.
13. Remove a wheel nave assembled with the blocking mechanism.
14. Remove disks and the top drafts.
15. Remove a steering bipod and the pendular lever assembled with drafts.
16. Carefully lower a differential case, without having damaged at the same time hinges.
17. Merge oil from a case, turn off 4 bolts of fastening of flanges of cases of half shafts to a differential case.

18. Get half shafts.


Installation

PERFORMANCE ORDER
1. Establish half shafts, wrap 4 bolts of fastening of flanges of cases of half shafts to a differential case.
2. Establish a steering bipod and the pendular lever assembled with drafts.
3. Establish disks and the top drafts.
4. Establish a wheel nave with the mechanism of automatic blocking.
5. Install the lower levers of a suspension bracket.
6. Attach shock-absorbers to the lower levers.
7. Attach steering thirsts for the lower levers.
8. Attach the top levers of a suspension bracket, without breaking initial quantity and an order of an arrangement of washers.
9. Attach tips of steering racks.
10. Establish supports of disk brakes.
11. Attach thirsts of the stabilizer for the lower levers.
12. Attach bars of racks of a forward suspension bracket.
13. Adjust clearance, having wrapped lever bolts.
14. Establish forward wheels and a towing frame.
15. Attach the driveshaft to differential.
16. Lower the car.