Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
4. System of decrease in toxicity
5. Fuel system
   5.1. Precautionary measures
   5.2. Order of depressurization of fuel system
   5.3. Mechanical fuel pump
   5.4. Electric fuel pump
   5.5. Removal and installation of the pump mounted in the fuel tank
   5.6. Adjustment of the carburetor
   5.7. Removal and installation of the carburetor
   5.8. Systems of injection of fuel
   5.9. Power supply system of diesels
      5.9.1. Fuel pump (TNVD)
      5.9.2. Idling adjustment
      5.9.3. Installation of the moment of injection
      5.9.4. Fuel tank
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Fuel system>> Power supply system of diesels>> Installation of the moment of injection

5.9.3. Installation of the moment of injection

GENERAL INFORMATION

The index for installation of the moment of injection on the C223 engine

Installation on tags for the C223 engine

Installation injection moments

1 – earlier

2 – later

PERFORMANCE ORDER
1. Check combination of tags on a pump housing and on an arm.
2. Install the piston of the 1st cylinder in compression step VMT. For combination it is necessary to use one of seven risok on a pulley.
3. Remove the top cover of a gear belt, check a tension of a belt and combination of tags.
4. Uncover heads of cylinders and a back cap. Check whether the control plate comes into a groove at a back end face of the camshaft.
5. Disconnect a tube from the pump, unscrew the screw and remove laying, then install the device for installation of the moment of injection consisting of the arrow indicator with a rod. Establish an indicator cam approximately in 1,0 mm from a pump plunger.
6. Install the piston of the 1st cylinder on 45-60 ° to VMT, expose an indicator scale on zero.
7. On a pulley is available a little рисок. Four risks are intended for installation of the moment of injection on the idle engine and are used when servicing. Three risks are intended for installation of the moment on the working engine and are used for adjustment industrially.
8. Turn a bent shaft before combination risks of 12 °C the index. Consider the indication of the arrow indicator which has to be 0,5 mm.
9. If the indication differs from norm, then establish a bent shaft in the provision of the moment of injection. Weaken two nuts on a pump flange.
10. Move the pump so that the indication of the indicator became equal 0,5 mm. Tighten flange nuts.