Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
   3.1. Specifications of the engine and adjusting works
   3.2. Electric equipment and capital repairs of engines
   3.3. Diesel engine 2,8 liters
      3.3.1. Introduction
      3.3.2. Technical characteristics
      3.3.3. Check of a compression
      3.3.4. Top dead point of the piston No. 1 (BMT)
      3.3.5. Gaps of valves
      3.3.6. Cover of a head of cylinders
      3.3.7. Pulley of a bent shaft
      3.3.8. Casings of a gear belt of the drive of the camshaft
      3.3.9. Gear belt of the drive of the camshaft
      3.3.10. Asterisks of a gear belt, natyazhitel and intermediate pulleys
      3.3.11. Yokes and pushers
      3.3.12. Head of the block of cylinders
      3.3.13. Oil case
      3.3.14. Oil pump
      3.3.15. Oil heater
      3.3.16. Epiploons of the camshaft and bent shaft
      3.3.17. Flywheel
      3.3.18. Fastenings of the engine / transmission
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Engines>> Diesel engine 2,8 liters>> Casings of a gear belt of the drive of the camshaft

3.3.8. Casings of a gear belt of the drive of the camshaft

TOP CASING

Removal

PERFORMANCE ORDER
1. Turn off fixing bolts of a protective plate of the engine and remove it.
2. Turn off and remove fixing bolts, then remove the top casing from the engine together with consolidation.
3. Examine consolidation on existence of wear tracks or damages and replace it if it is necessary.

Installation

PERFORMANCE ORDER
1. Installation is carried out upside-down removals.
2. Check that consolidation was correctly established.
3. Tighten fixing bolts of a casing till the required inhaling moment.

NIZHNY NOVGOROD (MAIN CASING)

Removal

PERFORMANCE ORDER
1. Remove the fan of cooling of a radiator.
2. Remove a pulley of a bent shaft.
3. Remove the top casing (see above), then turn off bolts of fastening of the lower casing and remove it from the engine together with consolidation.
4. Examine consolidation on existence of wear tracks or damages and replace it if it is necessary.

Installation

PERFORMANCE ORDER
1. Check that consolidation was correctly established in a casing flute, then apply a sealant strip on the top part of consolidation located under the water pump.
2. Install the lower casing on the engine, having checked that consolidation was not shifted, and tighten fixing bolts till the required inhaling moment.
3. Establish the top casing and consolidation and tighten fixing bolts till the required inhaling moment.
4. Establish a pulley of a bent shaft.
5. Install the fan of cooling of a radiator.