Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
   3.1. Specifications of the engine and adjusting works
   3.2. Electric equipment and capital repairs of engines
   3.3. Diesel engine 2,8 liters
      3.3.1. Introduction
      3.3.2. Technical characteristics
      3.3.3. Check of a compression
      3.3.4. Top dead point of the piston No. 1 (BMT)
      3.3.5. Gaps of valves
      3.3.6. Cover of a head of cylinders
      3.3.7. Pulley of a bent shaft
      3.3.8. Casings of a gear belt of the drive of the camshaft
      3.3.9. Gear belt of the drive of the camshaft
      3.3.10. Asterisks of a gear belt, natyazhitel and intermediate pulleys
      3.3.11. Yokes and pushers
      3.3.12. Head of the block of cylinders
      3.3.13. Oil case
      3.3.14. Oil pump
      3.3.15. Oil heater
      3.3.16. Epiploons of the camshaft and bent shaft
      3.3.17. Flywheel
      3.3.18. Fastenings of the engine / transmission
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Engines>> Diesel engine 2,8 liters>> Fastenings of the engine / transmission

3.3.18. Fastenings of the engine / transmission

Check

PERFORMANCE ORDER
1. If you need more convenient access to the examined parts, lift a forward part of the car a jack and fix it on support under axes.
2. If necessary unscrew fixing bolts and remove a protective plate of the engine.
3. Examine the rubber shock-absorber of fastening, check whether it burst, whether hardened and whether it was disconnected from fastening. Replace fastening if you find any damages.
4. Check that carving fastenings were reliably tightened.
5. Using the big screw-driver or mount as the lever and having raised the engine, check, fastening is worn how out.
6. If you cannot raise the engine by means of the lever, ask the assistant to move the engine forward and back or here and there until you examine fastening.
7. If you observe at the same time excessively free wheeling, check whether clips are well tightened, and then replace worn-out details.

Replacement

PERFORMANCE ORDER
The fastenings located with left and on the right side
1. Unscrew bolts, the fixing fastenings located with left and on the right side to a body of the car and turn off nuts, the fixing fastenings to engine arms.
2. Lift the engine by means of specially intended elevator and get fastenings.
3. To establish fastenings into place, perform operations on removal of fastenings upside-down.
4. Tighten fixing bolts and nuts till the required inhaling moment.
Back fastening
5. Turn off the nuts fixing back fastening to a cross-piece, and then unscrew the bolts fixing a fixing plate to the lower party of a case of the transmission.
6. Establish a jack under a back part of the transmission and lift a jack so that it was possible to remove back fastening.
7. Having established fastening on a desktop, turn off fixing nuts and remove the rubber shock-absorber of fastening from a fixing plate.
8. Installation is carried out upside-down removals.
9. At installation reliably put all clamps and bolts.