Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
   3.1. Specifications of the engine and adjusting works
   3.2. Electric equipment and capital repairs of engines
   3.3. Diesel engine 2,8 liters
      3.3.1. Introduction
      3.3.2. Technical characteristics
      3.3.3. Check of a compression
      3.3.4. Top dead point of the piston No. 1 (BMT)
      3.3.5. Gaps of valves
      3.3.6. Cover of a head of cylinders
      3.3.7. Pulley of a bent shaft
      3.3.8. Casings of a gear belt of the drive of the camshaft
      3.3.9. Gear belt of the drive of the camshaft
      3.3.10. Asterisks of a gear belt, natyazhitel and intermediate pulleys
      3.3.11. Yokes and pushers
      3.3.12. Head of the block of cylinders
      3.3.13. Oil case
      3.3.14. Oil pump
      3.3.15. Oil heater
      3.3.16. Epiploons of the camshaft and bent shaft
      3.3.17. Flywheel
      3.3.18. Fastenings of the engine / transmission
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Engines>> Diesel engine 2,8 liters>> Epiploons of the camshaft and bent shaft

3.3.16. Epiploons of the camshaft and bent shaft

CAMSHAFT EPIPLOON

Replacement

PERFORMANCE ORDER
1. Remove a camshaft asterisk.
2. By means of the screw-driver accurately remove an epiploon, trying not to damage the camshaft or a casing.
3. Clear a nest of an epiploon and remove jags or sharp edges which could lead to an epiploon exit out of operation.
4. Oil an edge of a new epiploon pure engine and establish an epiploon into place. If it is necessary, use a mandrel which needs to be established on a firm outer edge of an epiploon.
5. Wash away the oil remains, then establish a camshaft asterisk.

FORWARD EPIPLOON OF THE BENT SHAFT

Replacement

PERFORMANCE ORDER
1. Remove an asterisk of a bent shaft (see subsection 3.2.2.26).
2. Carefully punch or drill in an epiploon two small holes opposite to each other. Twist two self-cutting screws in both openings and pull for screws flat-nose pliers to get an epiploon.
3. An epiploon groove also polish with Prochistte all agnails which first of all can lead to damage of an epiploon.
4. Oil edges of a new epiploon pure engine.
5. Establish an epiploon for the end of a bent shaft and insert it into a groove (the epiploon has to act on 0,9±0,3 mm). In case of need to insert an epiploon into a groove, you can use tubular шлямбур which needs to be established on a firm outer edge of an epiploon. Be very careful and do not damage epiploon edges in installation time. Check that edges of an epiploon were directed inside.
6. Establish an asterisk of a bent shaft (see subsection 3.2.2.26).

BACK EPIPLOON OF THE BENT SHAFT

Replacement

PERFORMANCE ORDER
1. Remove a flywheel.
2. Replace an epiploon. Do not forget that the epiploon has to act on 1,25±0,3 mm.
3. Establish a flywheel.