Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
   3.1. Specifications of the engine and adjusting works
   3.2. Electric equipment and capital repairs of engines
      3.2.1. Electric equipment of engines
      3.2.2. Capital repairs of engines Technical characteristics Instructions on service and repair of the engine Dismantle and installation of the power unit Cover of a head of cylinders Yokes and rollers of yokes Thermostat The soaking-up collector Final collector Turbocompressor Conditioner Radiator The cooling system fan with the drive from the electric motor Pump of cooling liquid Head of cylinders Valves and springs
   Check of springs
   The directing plugs of valves
   Saddles of valves
   Grinding in of valves Pushers Oil pallet Oil pump Epiploon of a forward cover of a gear belt Chain of the drive of the camshaft and asterisk of the drive Forward cover of a gear belt Epiploon of a bent shaft Gear belt and natyazhitel Gear belt and mechanism of a tension Drive of the gas-distributing mechanism petrol engines Drive of the gas-distributing mechanism diesel engines Camshaft Camshaft bearings Pistons and rods Conrod bearings Assembly of conrod and piston group and installation on the engine Caps and heater of a case of the engine Back epiploon of a bent shaft Bent shaft and radical bearings Flywheel and gear wreath
   3.3. Diesel engine 2,8 liters
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries

Isuzu Trooper>> Engines>> Electric equipment and capital repairs of engines>> Capital repairs of engines>> Valves and springs Valves and springs


Removal of springs of valves

Compression of springs of valves

Wear of a core of the valve

1 – normal wear
2 – the picture of rotary wear is absent
3 – picture of incomplete rotation

Installation of oil scraper caps on a valve core

1 – plate

2 – spring

3 – valve

4 – oil scraper cap

Grinding of valves is carried out only in specialized workshops.

1. Before removal apply tags on heads of valves, having turned a head of cylinders.
2. Squeeze springs of valves, get crackers.
3. Release adaptation and remove a spring and a plate of a spring.
4. Wash out a valve core from a deposit and resinous deposits in solvent for varnishes.
5. Wash out the directing plugs by means of the wire brush moistened with solvent.
6. At detection of traces of considerable wear of a detail replace.