Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
   3.1. Specifications of the engine and adjusting works
   3.2. Electric equipment and capital repairs of engines
      3.2.1. Electric equipment of engines
         3.2.1.1. Ignition coil
         3.2.1.2. Ignition block
         3.2.1.3. The induction sensor of ignition for V6 engines
         3.2.1.4. Ignition distributor
         3.2.1.5. System of a charge of the battery
            3.2.1.5.1. Generator
            3.2.1.5.2. External regulator of tension
            3.2.1.5.3. Built-in regulator of tension
         3.2.1.6. System of launch of the engine
      3.2.2. Capital repairs of engines
   3.3. Diesel engine 2,8 liters
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Engines>> Electric equipment and capital repairs of engines>> Electric equipment of engines>> System of a charge of the battery>> External regulator of tension

3.2.1.5.2. External regulator of tension

GENERAL INFORMATION

The regulator represents the electromagnetic relay of the return current. Is established on engines of early release. It is mounted on the left mudguard in a motor compartment.

Adjustment

PERFORMANCE ORDER
1. Remove the regulator from the car.
2. If on contacts there are signs of an erosion, then clear them an emery paper.
3. At first clear a gap in the core, and then – contacts.
4. Adjust a gap in the core for what release screws of fastening of a contact plate to a yoke. Move a contact plate up or down so that the gap was within 0,6–1,0 mm. Tighten screws.
5. Adjust a gap in contacts for what release the screw of fastening of the top contact. Move contact up or down and establish a gap within 0,3–0,4 mm.
6. Adjust tension at the exit of the regulator rotating the adjusting screw. For increase in tension wrap the screw, for decrease – turn off. Stop the screw a lock-nut. The adjusted tension has to be within 13,8–14,8 Century.
7. Establish a regulator cover, attach wires and install the regulator.

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Disconnect from the regulator of a wire and mark them.
3. Unscrew two screws of fastening of the regulator and remove the regulator.
4. Install the regulator.
5. Attach wires.
6. Connect the battery to weight.