Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
   3.1. Specifications of the engine and adjusting works
   3.2. Electric equipment and capital repairs of engines
      3.2.1. Electric equipment of engines
         3.2.1.1. Ignition coil
         3.2.1.2. Ignition block
         3.2.1.3. The induction sensor of ignition for V6 engines
         3.2.1.4. Ignition distributor
         3.2.1.5. System of a charge of the battery
            3.2.1.5.1. Generator
               3.2.1.5.1.1. Removal and installation
               3.2.1.5.1.2. Dismantling and check
            3.2.1.5.2. External regulator of tension
            3.2.1.5.3. Built-in regulator of tension
         3.2.1.6. System of launch of the engine
      3.2.2. Capital repairs of engines
   3.3. Diesel engine 2,8 liters
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Engines>> Electric equipment and capital repairs of engines>> Electric equipment of engines>> System of a charge of the battery

3.2.1.5. System of a charge of the battery

3.2.1.5.1. Generator

GENERAL INFORMATION

Details of the generator of engines of early models

1 – bolts
2 – a forward cover assembled with a rotor
3 – nut
4 – pulley
5 – krylchatka
6 – cover
7 – forward bearing
8 – a back cover assembled with the stator
9 – stator assembled
10 – knot of the brush holder and rectifier
11 – brushes and condenser

Details of the generator of diesel engines combined with the vacuum pump

1 – a back cover assembled with the stator
2 – plait of wires
3 – built-in regulator of tension
4 – brush holder
5 – brush holder arm
6 – rectifier
7 – stator assembled
8 – screws
9 – condenser
10 – washers and nuts of fastening of the plug
11 – forward cover assembled
12 – forward cover
13 – ball bearing
14 – bearing case cover
15 – rotor assembled
16 – ball bearing
17 – rotor
18 – plug
19 – a pulley assembled with a krylchatka
20 – krylchatka
21 – pulley
22 – nut
23 – coupling bolt
24 – a brush assembled with the brush holder
25 – cover
26 – vacuum pump

On cars generators of three-phase current with connection of windings a star are installed. On V6 engines (6-cylinder) three-phase generators with connection of windings a triangle are installed.


Prevention

The generators installed on cars of the last releases are not subject to service and repair.


Precautionary measures

To prevent failure of the on-board computer, generator and regulator of tension, it must be kept in mind the following:

  – the battery polarity reversal is forbidden;
  – at launch of the engine from the auxiliary battery be convinced of correctness of its connection;
  – at shutdown and connection of any consumer always switch off ignition;
  – at the forced battery charging and the car always disconnect power cables;
  – launch of the engine from the external charger is forbidden;
  – it is forbidden to connect on weight a generator conclusion energized;
  – it is forbidden to disconnect a generator loading chain when in a winding of excitement current flows;
  – it is forbidden to polarize the generator.