Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
   3.1. Specifications of the engine and adjusting works
   3.2. Electric equipment and capital repairs of engines
      3.2.1. Electric equipment of engines
         3.2.1.1. Ignition coil
         3.2.1.2. Ignition block
            3.2.1.2.1. Check without removal
            3.2.1.2.2. Removal and installation
         3.2.1.3. The induction sensor of ignition for V6 engines
         3.2.1.4. Ignition distributor
         3.2.1.5. System of a charge of the battery
         3.2.1.6. System of launch of the engine
      3.2.2. Capital repairs of engines
   3.3. Diesel engine 2,8 liters
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Engines>> Electric equipment and capital repairs of engines>> Electric equipment of engines>> Ignition block

3.2.1.2. Ignition block

3.2.1.2.1. Check without removal

TROOPER, TROOPER II, AMIGO/JAZZ AND RODEO/PASSPORT C CARS ENGINES 4ZD1 AND 4ZE1

PERFORMANCE ORDER
1. Uncover the ignition distributor.
2. Disconnect a high-voltage wire from the distributor. Bring the termination of a wire to a bolt of fastening of the coil on distance of 5,0 mm.
3. Include ignition.
4. Connect to a conclusion of a red wire of the block of ignition a positive pole of the battery with tension 1,5 B, and to a conclusion of a white wire – a negative pole.
Prevention

It is possible to give food for the period of no more than 3 sec., otherwise the switchboard transistor will fail.


5. The block is considered serviceable if at disconnection of one of the attached wires in a gap of a high-voltage wire there is a spark.
6. If there is no spark, then replace the block of ignition.
7. Attach conducting and all being removed details.