Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
   3.1. Specifications of the engine and adjusting works
      3.1.1. Spark plugs
      3.1.2. Installation of ignition
      3.1.3. Installation of the moment of injection of fuel
      3.1.4. Electronic ignition
      3.1.5. Adjustment of gaps of valves
      3.1.6. Adjustment of turns of idling on carburetor engines
      3.1.7. Adjustment of turns of idling on engines with system of injection
      3.1.8. Adjustment of turns of idling on diesel engines
   3.2. Electric equipment and capital repairs of engines
   3.3. Diesel engine 2,8 liters
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Engines>> Specifications of the engine and adjusting works>> Installation of the moment of injection of fuel

3.1.3. Installation of the moment of injection of fuel

GENERAL INFORMATION

DIESEL ENGINES

Tags for installation of the moment of injection of fuel on the diesel C223


Tags for establishment of the crankshaft in VMT and the provision of the beginning of injection (according to tabular data)


Adjustment of provision of TNVD

1 – reduction of a corner of the moment of injection

2 – increase in a corner of the moment of injection

PERFORMANCE ORDER
1. Combine risks on a pump housing and on an assembly plate.
2. Having turned a bent shaft, you will expose the piston of the 1st cylinder in the provision of VMT of a step of compression. On a pulley-uspokoitele seven marks therefore for exposure of the piston it is necessary to find the necessary mark in VMT are provided.
3. Remove the top cover of a gear belt, check a tension of a belt and combination of adjusting tags.
4. Uncover a head of cylinders and get a back cap, be convinced that the fixing plate freely comes in vents at a back end face of a cam-shaft.
5. Disconnect a fuel-supply line of high pressure from TNVD, unscrew the screw of a distributive head, remove laying and install indicator adaptation. Establish the size of raising of 1,0 mm from a plunger.
6. Turn the crankshaft on 45-60 ° from VMT back, install the indicator on zero.
7. On an uspokoitel there are seven tags – four tags for installation on the idle engine and three tags for installation on the working engine which are used only industrially.
8. Turn the crankshaft before combination of a tag 12 ° on an uspokoitel with the index then consider the indication of the indicator which has to be 0,5 mm.
9. If the indication differs from standard, then turn the crankshaft in situation which corresponds to the beginning of the moment of injection (see the tab. Adjusting data for diesel engines (without diesel engine 2,8 liters *)). Turn off two nuts of fastening of a flange of the pump.
10. Install the pump in such situation at which the indicator will show 0,5 mm. Tighten nuts.