Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
   2.1. Data on identification of the car
   2.2. General data of engines
   2.3. THAT the Trooper/Bighorn cars with the diesel engine
   2.4. Instructions on leaving
      2.4.1. Air filter
      2.4.2. Fuel filter (petrol engines)
      2.4.3. Fuel filter (diesel engines)
      2.4.4. Draining of the water which collected in fuel system of the diesel engine
      2.4.5. Compulsory system of ventilation of a case (PCV system)
      2.4.6. A tank for catching of vapors of gasoline
      2.4.7. Features of check of system of catching of vapors
      2.4.8. Rechargeable battery
      2.4.9. Drive belts
      2.4.10. Cooling system
      2.4.11. Air conditioning system
      2.4.12. Screen wiper
      2.4.13. The recommended brands of fuel and oil
      2.4.14. Care of the manual transmission or automatic transmission
      2.4.15. Check of level of oil or liquid
      2.4.16. Oil replacement
      2.4.17. Case of the transfer case
      2.4.18. Reducer of the back bridge
      2.4.19. Cooling liquid
         2.4.19.1. Check of level of cooling liquid
         2.4.19.2. Replacement of cooling liquid
      2.4.20. Main brake cylinder
      2.4.21. Main cylinder of a hydraulic actuator of coupling
      2.4.22. Nutritious tank of the power steering
      2.4.23. Reducer of the steering mechanism
      2.4.24. Lubricant of a running gear
      2.4.25. Body lubricant
      2.4.26. Lubricant of the mechanism of the emergency brake
      2.4.27. Lubricant of draft of the drive of a butterfly valve
      2.4.28. Gear shifting lever lubricant
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Maintenance>> Instructions on leaving>> Cooling liquid>> Replacement of cooling liquid

2.4.19.2. Replacement of cooling liquid

GENERAL INFORMATION

Stopper of a drain opening

1 – stopper of a drain opening
Every 24 month or 50000 km of a run it is necessary to merge liquid from the cooling system, to wash out system and to fill in the fresh liquid recommended by the manufacturer. Liquid is replaced on the cold engine.

PERFORMANCE ORDER
1. Turn off a radiator mouth stopper. Start the engine and wait in the top hose so far it will warmly not be felt that points to full opening of the thermostat.
2. Stop the engine and substitute the pallet under a radiator. Open a drain faucet in a ground part of a radiator and merge liquid. If drain traffic jams of cooling liquid are provided in the block of cylinders, then turn out them.
3. Wrap the crane and fill the cooling system with clear water. Merge water. Repeat the procedure until clear water pours down.
4. Fill in mix of water and antifreeze in a proportion 50/50 to a radiator mouth. Warm up the engine until the top hose of a radiator does not become hot (at an open mouth of a radiator). On the working engine add mix of water and antifreeze in a proportion 50/50 to the necessary level. Close a radiator a stopper.