Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
   2.1. Data on identification of the car
   2.2. General data of engines
   2.3. THAT the Trooper/Bighorn cars with the diesel engine
   2.4. Instructions on leaving
      2.4.1. Air filter
      2.4.2. Fuel filter (petrol engines)
      2.4.3. Fuel filter (diesel engines)
      2.4.4. Draining of the water which collected in fuel system of the diesel engine
      2.4.5. Compulsory system of ventilation of a case (PCV system)
      2.4.6. A tank for catching of vapors of gasoline
      2.4.7. Features of check of system of catching of vapors
      2.4.8. Rechargeable battery
      2.4.9. Drive belts
      2.4.10. Cooling system
      2.4.11. Air conditioning system
      2.4.12. Screen wiper
      2.4.13. The recommended brands of fuel and oil
      2.4.14. Care of the manual transmission or automatic transmission
      2.4.15. Check of level of oil or liquid
      2.4.16. Oil replacement
      2.4.17. Case of the transfer case
      2.4.18. Reducer of the back bridge
      2.4.19. Cooling liquid
      2.4.20. Main brake cylinder
      2.4.21. Main cylinder of a hydraulic actuator of coupling
      2.4.22. Nutritious tank of the power steering
      2.4.23. Reducer of the steering mechanism
      2.4.24. Lubricant of a running gear
      2.4.25. Body lubricant
      2.4.26. Lubricant of the mechanism of the emergency brake
      2.4.27. Lubricant of draft of the drive of a butterfly valve
      2.4.28. Gear shifting lever lubricant
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Maintenance>> Instructions on leaving>> Cooling system

2.4.10. Cooling system

GENERAL INFORMATION

It is necessary to check the level of cooling liquid monthly. Level has to be between tags of "Full Cold" and "Full Hot". It is necessary to add mix of water and antifreeze in a proportion 50/50 irrespective of an operation season. Along with check of level it is necessary to check a condition of hoses. And damages replace hoses with wear tracks.


Prevention

Every 2 year or 50000 km of a run it is necessary to merge liquid from the cooling system, to wash out system and to fill in the fresh liquid recommended by the manufacturer.


Check

PERFORMANCE ORDER
1. Turn off a radiator mouth stopper on the cooled-down engine.
2. After the stopper is removed, start the engine and wait until in the top hose it is warmly felt that indicates full opening of the thermostat. Transfer a rychazhok of management of a heater to the situation corresponding to full opening of an inlet branch pipe of a radiator of a heater.
3. Stop the engine and open a drain faucet in a ground part of a radiator. Merge liquid.
4. Wrap a stopper and fill the cooling system with clear water. At desire it is possible to add the washing additives.
5. Warm up the engine.
6. Merge water. Repeat the procedure until clear water pours down.
7. Clear a broad tank for what turn out a tank stopper. Having raised a tank, merge the remains of liquid and wash out a tank water with soap, then merge and put a tank into place.
8. Close a faucet and fill in mix of water and antifreeze in a proportion 50/50 to a radiator mouth. Add liquid in a broad tank to the mark "Full Hot". Close a tank a stopper.
9. Warm up the engine until the top hose of a radiator does not become hot (at an open mouth of a radiator). On the working engine add mix of water and antifreeze in a proportion 50/50 to the radiator mouth basis. Stop the engine and close a radiator a stopper, having combined an arrow with the hose union from a broad tank. Close the heater crane.