Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
   1.1. Introduction
   1.2. Dashboard
   1.3. Ignition lock
   1.4. The combined switch
   1.5. Alarm light system
   1.6. Dashboard switches
   1.7. Cruise control
   1.8. Devices and control lamps
   1.9. Control levers
   1.10. Windows and window regulators
   1.11. Illumination of salon
   1.12. Electric digital watch
   1.13. Governing bodies of heating and fan or conditioner
   1.14. Driving
   1.15. Production of air from fuel system
   1.16. Depletion of a water separator
   1.17. Regular checks
   1.18. Service of the air filter
   1.19. Replacement of engine oil
   1.20. Block of safety locks
   1.21. Technical characteristics
2. Maintenance
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Maintenance instruction>> Depletion of a water separator

1.16. Depletion of a water separator

GENERAL INFORMATION

You keep the capacity (volume of 0,2 l) under the end of a vinyl hose at the final screw of a water separator.

Unscrew the final screw and about 10 times press the manual pump, about 0,1 l of water will not flow out yet.

Then again tighten the screw and several times press the manual pump.

After start of the engine you watch that from the final screw fuel did not act.

Also check whether the alarm lamp went out.

If often it is necessary to empty a water separator, it is necessary that the fuel tank was dehydrated by the expert.