Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
   10.1. System of heating and air conditioning
   10.2. Receiver
   10.3. Electric motor of a screen wiper of a windshield, draft of the drive of brushes
   10.4. Electric motor of a screen wiper of back glass
   10.5. Devices and switches
      10.5.1. Guard of devices
      10.5.2. Speedometer
      10.5.3. Index of level of fuel
      10.5.4. Fuel level sensor
      10.5.5. Forward panel
      10.5.6. Windshield screen wiper switch
      10.5.7. Switch of a screen wiper of back glass
      10.5.8. Switch of headlights
      10.5.9. Switch of light of headlights
      10.5.10. Ignition switch
      10.5.11. Speedometer drive cable
      10.5.12. Light devices
      10.5.13. Devices of the light alarm system
      10.5.14. The list of the lamps applied in the Trooper/Bighorn car
      10.5.15. The list of the lamps applied in the Rodeo car
   10.6. Cruise control
   10.7. Unblocking device
   10.8. Devices of protection against overloads
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Body electric equipment>> Devices and switches>> Switch of light of headlights

10.5.9. Switch of light of headlights

GENERAL INFORMATION

The switch of light of headlights on the Trooper/Bighorn cars
1 – dim light (maximum resistance)
2 – bright light (minimum resistance)
3 – block of safety locks (wire of green-white, 0,85 mm2)
4 – thermobimetallic breaker (wire of red, 1,25 mm2)
5 – lamps of dimensional lamps, side repeaters of turn (wire of green-red, 0,85 mm2)
6 – brightness regulator switch (wire of red-white, 1,25 mm2)
7 – having tidied up lamps of a guard (a wire of green-red, 0,85 mm2)
8 – provisions of the switch, situation "is switched off"

The switch of light of headlights on the Amigo/MU/Jazz and Rodeo/Passport cars
1 – guard of devices

2 – socket

3 – switch

Removal and installation

AMIGO/MU/JAZZ AND RODEO/PASSPORT CARS

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Remove a guard of devices.
3. Unscrew screws and remove the switch.
4. Installation is carried out upside-down.