Isuzu Trooper - Isuzu Trooper
1. Maintenance instruction
2. Maintenance
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and running gear
7. Suspension bracket and steering
8. Brake system
9. Body
10. Body electric equipment
   10.1. System of heating and air conditioning
   10.2. Receiver
   10.3. Electric motor of a screen wiper of a windshield, draft of the drive of brushes
   10.4. Electric motor of a screen wiper of back glass
   10.5. Devices and switches
      10.5.1. Guard of devices
      10.5.2. Speedometer
      10.5.3. Index of level of fuel
      10.5.4. Fuel level sensor
      10.5.5. Forward panel
      10.5.6. Windshield screen wiper switch
      10.5.7. Switch of a screen wiper of back glass
      10.5.8. Switch of headlights
      10.5.9. Switch of light of headlights
      10.5.10. Ignition switch
      10.5.11. Speedometer drive cable
      10.5.12. Light devices
         10.5.12.1. Headlights
      10.5.13. Devices of the light alarm system
      10.5.14. The list of the lamps applied in the Trooper/Bighorn car
      10.5.15. The list of the lamps applied in the Rodeo car
   10.6. Cruise control
   10.7. Unblocking device
   10.8. Devices of protection against overloads
11. Diagnostics of malfunctions
12. Electrical circuitries





Isuzu Trooper>> Body electric equipment>> Devices and switches>> Light devices

10.5.12. Light devices

10.5.12.1. Headlights

USUAL HEADLIGHTS

Adjustment of a beam of light of a usual headlight

1 – screw A

2 – screw B

Removal and installation


PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Remove a forward lattice or a decorative slip.
3. Remove a frame, get a lamp and disconnect wires.
4. Before installation apply a thin film of aerosol silicone lubricant on a socle.
5. Attach wires and establish a lamp.
6. Establish a lattice or a slip and wrap screws.
7. Adjustment: in the vertical plane the bunch is regulated by rotation of the screw A, in horizontal – the screw B.

AERODYNAMIC HEADLIGHTS

Adjustment of a bunch on the Trooper/Bighorn and Rodeo/Passport cars

 

Removal of a lamp

1 – frame

2 – socket

3 – a lamp with a socle


Removal and installation


PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Open a cowl and disconnect the socket from a headlight.
3. Turn a lamp and get from the case.

Prevention

It is forbidden to touch a halogen lamp with fingers, otherwise because of pollution of a cylinder the lamp can fuse. In case of pollution wipe a cylinder with the fabric moistened in alcohol.


4. Establish a lamp, holding for a plastic part, attach wires.
5. Adjust a bunch.